BeerSmith™ Home Brewing Forum
BeerSmith Software => BeerSmith 3 Support => Topic started by: Tachinomia on June 18, 2018, 06:51:40 PM
-
Hello everyone,
As I am about to use Beersmith 3 I just checked if the calibration data from v2 had been imported to v3, which does not seem to be the case. So instead of re-calibrating, because I have not brewed yet, I decided to use the numbers I got from v2 and use them for v3.
So, in v2 my calibration numbers were 14,80 Brix and 1,060 for the hydro with a correction factor of 1,00952 but when I enter these same numbers in v3 it gives me a correction factor of 1,00398...
Any ideas?
Thanks in advance!