BeerSmith™ Home Brewing Forum

BeerSmith Software => BeerSmith 3 Support => Topic started by: toppa on June 10, 2021, 07:02:09 PM

Title: Final Mash pH adjustments not calculating
Post by: toppa on June 10, 2021, 07:02:09 PM
I've set up the water profile and mash steps. When I adjust the measured mash pH to get an estimated addition of acid, the acid amount remains at 0.
When I add a quantity of acid in the "mash pH acid additions section" The adjusted mash pH figure becomes -1.#J which i'm assuming is an error.

Am I doing anything wrong or is this a bug?
I'm on 3.2.7
Title: Re: Final Mash pH adjustments not calculating
Post by: toppa on June 10, 2021, 07:24:00 PM
Figured it out!
Need to add strike water as part of the mash steps.