Author Topic: Plugging hole in keggle  (Read 3009 times)

Offline JackKerley

  • BeerSmith Apprentice Brewer
  • **
  • Posts: 4
    • JAK
Plugging hole in keggle
« on: April 29, 2014, 04:42:30 PM »
New to brewing, I got a bargain on a used keggle fitted with spout and thermometer, the only drawback is the thermometer is mounted too high for my 3 and 5-gallon batches. I'd like to re-set it down a few inches, no problem except filling the hole. Are weldless plugs available … basically a bulkhead fitting sans the port? Thanks.

Offline cmbrougham

  • BeerSmith Grandmaster Brewer
  • *****
  • Posts: 348
  • I brews easily.
Re: Plugging hole in keggle
« Reply #1 on: April 29, 2014, 05:16:24 PM »
I don't think there is any specific assembly you can buy to achieve this, but it's certainly doable. A 1/2 NPT male plug with a silicone o-ring and a stainless locknut on the inside should do the job. You can find all of these here: Fittings / Camlock. I'd recommend emailing Bobby at and explaining the situation--he'll help you get the right parts.