Author Topic: BIAB Cooler Mash Profile  (Read 4909 times)

Offline double_d

  • BeerSmith New Brewer
  • *
  • Posts: 1
  • BeerSmith 2 Rocks!
BIAB Cooler Mash Profile
« on: May 29, 2015, 11:30:17 AM »
I'm looking at moving to 10 gallon BIAB with 2 vessels. How would I go about setting up the mash profile for a 30 gallon cooler and a 15 gallon pot? 

Offline Oginme

  • BeerSmith Grandmaster Brewer
  • *****
  • Posts: 3123
  • Goats, guitars, and a home brew; Life is good!
    • Longvu LaManchas
Re: BIAB Cooler Mash Profile
« Reply #1 on: May 29, 2015, 12:35:03 PM »
Just take a single infusion profile and edit it to reflect your vessel sizes.  Make sure you click the box for 'BIAB mash with full boil' if that is what you are doing.  If you are planning on sparging, it is really no different than having a traditional mash tun and you can leave it as a single infusion profile.
Recycle your grains, feed them to a goat!

Offline durrettd

  • BeerSmith Grandmaster Brewer
  • *****
  • Posts: 392
Re: BIAB Cooler Mash Profile
« Reply #2 on: May 30, 2015, 03:44:28 PM »
Read this:    http://www.beersmith.com/forum/index.php/topic,5140.0.html

These instructions are for a more traditional mash/lauder tun, but they should be applicable to your BIAB system. The important point is to ensure all your losses are considered: grain absorption, mash tun deadspace (yours should be zero), boil-off, kettle deadspace, and trub.

 

modification