BeerSmith Software > BeerSmith 2 Bugs/Support

Total Water needed for brewing with extract bug

<< < (2/2)

CascadesBrewer:
Throwing a "me too...many years later" response.  A search did not turn up another discussion of this issue, but it seems to still exist in BeerSmith 3 Mobile.

I am normally an all-grain brewer, but I am working on an extract recipe.  The "Total Water Needed" value shows 2.5 gals (which is my top up volume).  Given the Estimated Pre-Boil Volume of 3.51 gal I can just figure that I need around that much water.

A side effect is that any water adjustments are out of whack on the Water Profile page.  Since they are only calculated for 2.5 gals, adding 5 grams of Gypsum says I will hit 324 ppm of Sulfate!

Navigation

[0] Message Index

[*] Previous page

Sitemap 
Go to full version