I have 2 issues using regulators .. 1 for beer, 1 using a regulator on a 5lb cartridge for Soda Stream.
I also don't recall bringing up other product names, so I will partially obscure them.
Beer Regulator:
I bought the Ke*$o LH-54S-2 Pro Series two product regulator to replace my old one regulator setup for 2 kegs. However, instead of a threaded CO2 connector, it just has a 5/16" barb. I need the threaded regulator. The only one I have been able to discover, thus far, is a CO2 Inlet Fitting LHT. Is the fitting in the regulator body LHT and the part that connects to the CO2 keg RHT ? Also, what kind of torque needs to be applied for seating, or just a snug fit as it is a rounded body on the adapter ? Second part of question, if the answer is no to the LHT in regulator and RHT connector, where on earth can one source this product ?
So$a St32am : I bought an adapter to connect the machine up directly to a 5lb CO2 tank. However, I am worried about pressure ratings. Not knowing what the rating of the small cartridge refills are (factory direct), I wanted to crank the pressure down to 10 PSI or so. I wanted to use my old regulator (one regulator with 2 outlets) to do this. What I am struggling to find is the same kind of CO2 connector to replace the two headed outlet with, and then to thread on a FxF adapter.
Any help appreciated.
I also don't recall bringing up other product names, so I will partially obscure them.
Beer Regulator:
I bought the Ke*$o LH-54S-2 Pro Series two product regulator to replace my old one regulator setup for 2 kegs. However, instead of a threaded CO2 connector, it just has a 5/16" barb. I need the threaded regulator. The only one I have been able to discover, thus far, is a CO2 Inlet Fitting LHT. Is the fitting in the regulator body LHT and the part that connects to the CO2 keg RHT ? Also, what kind of torque needs to be applied for seating, or just a snug fit as it is a rounded body on the adapter ? Second part of question, if the answer is no to the LHT in regulator and RHT connector, where on earth can one source this product ?
So$a St32am : I bought an adapter to connect the machine up directly to a 5lb CO2 tank. However, I am worried about pressure ratings. Not knowing what the rating of the small cartridge refills are (factory direct), I wanted to crank the pressure down to 10 PSI or so. I wanted to use my old regulator (one regulator with 2 outlets) to do this. What I am struggling to find is the same kind of CO2 connector to replace the two headed outlet with, and then to thread on a FxF adapter.
Any help appreciated.