switzead
Brewer
I did an extract batch (first time using BS software). I added the extract to a full volume boil. On the session tab and on the Brew Sheet the estimated pre-boil gravity is higher than the estimated post-boil gravity. This is impossible as water is evaporated off the gravity should go up. Below are the numbers I see in the program. My actual pre-boil vol was 8.42 gallons at 1.039 gravity and post-boil gravity measured 1.050. I'm sure it has something to do with my equipment setup but I cant figure it out. Its like the software is assuming that I am doing a partial volume boil and then topping up but the est pre and post boil volumes are dead on.
Session Tab
Est Pre-Boil Vol - 8.17
Est Pre-Boil Gravity - 1.055
Est Original Gravity - 1.051
Brew Sheet
Est Pre-Boil Vol - 8.17
Est Pre-Boil Gravity - 1.055
Est Post-Boil Vol - 7.07
Est Original Gravity - 1.051
Session Tab
Est Pre-Boil Vol - 8.17
Est Pre-Boil Gravity - 1.055
Est Original Gravity - 1.051
Brew Sheet
Est Pre-Boil Vol - 8.17
Est Pre-Boil Gravity - 1.055
Est Post-Boil Vol - 7.07
Est Original Gravity - 1.051