Author Topic: Acid addition  (Read 820 times)

Offline jmiliz

  • BeerSmith Apprentice Brewer
  • **
  • Posts: 4
  • BeerSmith 2 Rocks!
Acid addition
« on: July 22, 2021, 05:44:00 AM »
I use a Blichmann BrewEasy system with the BIAB mash profile as suggested. When I calculate acid to add (I start with RO water) i would guess its calculating for the entire volume of water. When I mash in however only a portion of the water is used and sits in the mash tun for 10-15 minutes before I start recirculation. Given the water:grain is not truly full volume for the first 10-15min will this affect the amount of acid to use and should I calculate the acid based on the amount of water I intend to put in the top mash tun rather than the entire volume?

Offline BeerSmith

  • Brewer, Author, Patriot
  • BeerSmith Administrator
  • BeerSmith Grandmaster Brewer
  • *****
  • Posts: 5568
  • BeerSmith - take the guesswork out of brewing!
    • BeerSmith
Re: Acid addition
« Reply #1 on: July 22, 2021, 12:13:34 PM »
If you pick a BIAB mash profile you will get the full volume of water added up front (its what I use with mine).  This will also force the water calculations to be full size if you adjust the water as the final step in building the recipe.
Get a free trial of BeerSmith 3 here