Author Topic: Anvil Foundry 10.5 w/ RIMS & Sparge  (Read 1983 times)

Offline mrossi22

  • BeerSmith New Brewer
  • *
  • Posts: 1
  • BeerSmith 3 Rocks!
Anvil Foundry 10.5 w/ RIMS & Sparge
« on: July 31, 2021, 05:31:45 PM »
Hello all,

Just recently purchased the Anvil Foundry 10.5 and I'm a bit confused as to how to set up my mash profile.  I purchased the recirculation pump and we have a secondary kettle that we'll be using to sparge after we pull the basket out.  Can anyone point me in the right direction for this?  I'm not sure if it's a modification to the existing BIAB profile or if I need to customize one.  Spent a few hours poking around in the various settings so I figured it'd be a good idea to see if anyone here has had any experience w/ this.

Appreciate the insight!



Offline joeinma

  • BeerSmith Brewer
  • ***
  • Posts: 37
Re: Anvil Foundry 10.5 w/ RIMS & Sparge
« Reply #1 on: August 11, 2021, 12:59:58 PM »

if you go to add ons tab and then select equipment, there are profiles for the 10.5 and 6.5 Foundry.  Whether you sparge or not would be determined when you select your mash profile, if sparging just don't check off the BIAB mash with full boil box.  Have a Foundry myself and will say the profile is pretty spot on. Do note that if you are going to use 240V,  you need to change the boil off to 1 gallon per hour.