BeerSmith 2.0.37, Windows 7
I noticed today that if I modify a recipe (say, adding or subtracting fermentables) the brew sheet does not change.
1) Open an existing all-grain recipe
2) Click Brew Steps, observe estimated pre-boil gravity, close the window
3) Add 5 pounds of some base malt
4) Open Brew Steps again
Expected result: pre-boil gravity is higher, new grain is listed under mash ingredients
Actual result: pre-boil gravity did not change, new grain is not listed
If I close the recipe and re-open it, the brew steps displays the new value. This affects other fields too, like total water needed and hops.
I noticed today that if I modify a recipe (say, adding or subtracting fermentables) the brew sheet does not change.
1) Open an existing all-grain recipe
2) Click Brew Steps, observe estimated pre-boil gravity, close the window
3) Add 5 pounds of some base malt
4) Open Brew Steps again
Expected result: pre-boil gravity is higher, new grain is listed under mash ingredients
Actual result: pre-boil gravity did not change, new grain is not listed
If I close the recipe and re-open it, the brew steps displays the new value. This affects other fields too, like total water needed and hops.