Author Topic: selecting multiple recipe entries  (Read 2913 times)

Offline iophon

  • BeerSmith Apprentice Brewer
  • **
  • Posts: 7
selecting multiple recipe entries
« on: June 17, 2011, 10:17:35 PM »
In 1.4 I could select multiple (contiguous) hop additions and increase or decrease the quantities by whatever increment I wanted - for hops I used 1 gram. I can no longer do this. For a "continuously" hopped IPA like dogfishhead this is a giant pain. Say I wanted to adjust all the hop additions in a recipe which are at 5 minute intervals counting down from 60 minutes. In order to change them all I used to be able to select them all and change the amount up or down using the increase/decrease button and immediately see what the IBU count was for the recipe. Now I have to select each of the 12 entries one by one, and change the amount one by one. If it is not what I want I then have to select each entry one by one again, and decrease each of them one by one...

AAARRRGGHH!

Offline BeerSmith

  • Brewer, Author, Patriot
  • BeerSmith Administrator
  • BeerSmith Grandmaster Brewer
  • *****
  • Posts: 5606
  • BeerSmith - take the guesswork out of brewing!
    • BeerSmith
Re: selecting multiple recipe entries
« Reply #1 on: June 18, 2011, 02:45:20 AM »
Hi,
  I'll certainly look at adding the multiple item adjustment back in - it should not be terribly hard to do. 

Thanks,
Brad
Get a free trial of BeerSmith 3 here

 

modification