No steps given in batch sparging

No steps given in batch sparging.
http://whitemtnbrewers.com/brews/Weed_Puller.html
as you can see, after mash steps it gives batch sparge as "Drain mash tun, Batch sparge with 0 steps () of 168.0 F water"

Here is a brew sheet done in ver. 1.4
http://whitemtnbrewers.com/brews/WP1.4.htm
And it calculated 3 rounds in the batch sparge.

Hi,
  Could you send the recipe to me (beersmith at my beersmith.com address via email) so I can debug it?

Thanks,
Brad

File sent

Thank You

Well, any luck?

I still have to use 1.4 until this bug is taken care of.

Hi,
  The problem was actually in your equipment profile - you had "top up water into kettle" set at 7 gallons which resulted in
way too much water in the system and the program calculating a negative sparge water addition (and no batches as a result).

  If you change your "top up water for kettle" to zero, you will get a positive sparge water volume and batches displayed
on the brewsheet.

Brad