Author Topic: Grain Mill Question  (Read 3462 times)

Offline fgmguy

  • BeerSmith New Brewer
  • *
  • Posts: 1
  • BeerSmith 2 Rocks!
Grain Mill Question
« on: April 14, 2012, 09:02:49 PM »
I just started brewing at Christmas (2011) and am now moving to all grain. I am considering getting a grain mill. My wife has a KitchenAide stand mixer and they sell a grain mill attachment. This attachment says that it will adjust from "barely cracked" to extra fine.

Does anybody know if this attachment works well for milling brew grains?

Offline Maine Homebrewer

  • BeerSmith Grandmaster Brewer
  • *****
  • Posts: 1371
Re: Grain Mill Question
« Reply #1 on: April 15, 2012, 05:28:04 AM »
I have a Corona mill that I run with a power drill, and I imagine my results that are similar to what you would get with that.
As it is my brewhouse efficiency varies between low 70s and mid 80s. 
I figure that if I had a roller mill I could get more consistent results that stay in the 80s.

As long as you're going to spend money, I would recommend springing for a roller mill.

Search this site. There have been several discussions on the merits of different mills.

There's all kinds of them out there.  Shop around.
"To alcohol! The cause of - and solution to - all of life's problems!" -Homer Simpson

Offline PetenNewburg

  • “In wine there is wisdom, in beer there is laughter, and in water there is bacteria” Benjamin Franklin
  • BeerSmith Grandmaster Brewer
  • *****
  • Posts: 148
Re: Grain Mill Question
« Reply #2 on: April 15, 2012, 05:52:16 AM »
  I have a cheap Chinese version of the Corona Mill.  I does a decent job by hand, but the casting quality is so poor that powering it with a drill yeilds very inconsistant results.  I have been looking at the various roller mills.  At this point the Barley Crusher list on the BeerSmith website looks like the best deal.  I will be moving up to 10+ gallon brews this summer so I think I'll go with the large hopper version.
Several meads ageing.
IPA kegged, 2/9/14
R. Porter in Secondary, 2/9/14
Next up, Vienna Lager, Pale Ale

Offline Kevin J

  • BeerSmith Brewer
  • ***
  • Posts: 36
Re: Grain Mill Question
« Reply #3 on: April 17, 2012, 03:26:30 PM »
The Barley crusher is great.

KernelCrush

  • Guest
Re: Grain Mill Question
« Reply #4 on: April 17, 2012, 06:13:17 PM »
Search lots of boards.  They all have their fans.  My 3D Crankandstein starts up with the hopper loaded and it takes longer to roll out the cart than it does to crush 20-25 lbs.

 

modification