BeerSmith™ Home Brewing Forum

BeerSmith Software => BeerSmith Mobile - Lite and Full => Topic started by: DildoShwagon on August 29, 2018, 11:13:21 PM

Title: Beersmith mobile question?
Post by: DildoShwagon on August 29, 2018, 11:13:21 PM
Hello I have a question about the fly sparging amounts uses in beersmith mobile. Well see I am just starting to understand beersmith mobile but I am little confused about the amount use for fly sparging here a picture of what I am talking about https://imgur.com/a/LALbLUf see in the picture it say to sparge with 10.53qt now  doesn?t that seem low for a sparging amounts?
Title: Re: Beersmith mobile question?
Post by: BeerSmith on September 17, 2018, 07:06:17 PM
The sparge water is calculated as what's needed to meet your preboil volume - specifically:
  sparge_vol = boil_vol + grain_absorb - kettle_top_up + mash_tun_deadspace - mash_vol;

 where:
  boil_vol is the target pre boil volume
  grain_absorb is the volume absorbed by the grain during the mash
  mash_vol is the total volume of water added during the mash
  mash_tun_deadspace is the deadspace value (from the equipment profile)
  kettle_top_up is the top up water (from equip profile) added to the kettle pre-boil

--
Brad