BeerSmith™ Home Brewing Forum

BeerSmith Software => BeerSmith 3 Support => Topic started by: Banjoblue on November 03, 2019, 03:02:22 AM

Title: How do I change the batch size without scaling the recipe?
Post by: Banjoblue on November 03, 2019, 03:02:22 AM
I have a robobrew profile based on a 23L batch which gives me the right measured OG against the estimated OG.  I want to increase the OG by reducing the batch size to 19L i.e. less water for the same grain bill.  how do I do that?   If I scale the batch it reduces the grain bill to keep the OG the same.
Title: Re: How do I change the batch size without scaling the recipe?
Post by: Oginme on November 03, 2019, 05:25:38 AM
Since you are keeping the same equipment profile and just altering the batch size, you don't need to use the "scale recipe" feature of BeerSmith.  Change your finished batch size on the design tab and the recipe should adjust using the same material bill, altering all the parameters of gravity, bitterness, color, and ABV based upon your original grain bill. 

Now if you want to make further adjustments, you can click on the sliders below the material box for each of the calculated parameters and enter in the new target.  BeerSmith will adjust the recipe accordingly to match your new target by altering the grain bill or hop additions proportionally to match your new target.

Note that this assumes that you will hit the same brew house efficiency with a lower batch size.  While this is possible, you will need to take careful measurements and record what your actual brew house and mash efficiency are with your reduced batch size so that if you choose to do this again, you can make those adjustments.  Better yet, you can then develop a new equipment profile to take into account your new batch size and efficiency so that you can then use the scale recipe tool to make these changes for you.
Title: Re: How do I change the batch size without scaling the recipe?
Post by: Banjoblue on November 04, 2019, 03:35:41 PM
Thankyou!