BarryTheHatchet
Apprentice
- Joined
- Jun 15, 2018
- Messages
- 7
- Reaction score
- 0
Hi
I seem to be having a problem with mash water volume calculations for partial mash recipes. I have tested this on partial mash recipes imported from BS2 and a test recipe created in BS3.
For example - When I change the weight of pale malt, the mash water volumes for mash in, mash out and sparge water can change dramatically to erroneous values. The Grain Mash Weight is also not updated until I open the Mash tab (which forces another calculation of mash volumes). To correct the mash water volumes I have to re-select the mash profile from the list.
I also noticed that after adjusting the grain weight if I changed other values such as hops and yeast that the mash volumes also change. I'm new to BS, but I'm pretty sure the mash volume shouldn't change if I add a packet of yeast to the recipe.
Perhaps someone can confirm this behavior on their system?
I'm running a registered version of BS3 on Windows 7
Thanks
I seem to be having a problem with mash water volume calculations for partial mash recipes. I have tested this on partial mash recipes imported from BS2 and a test recipe created in BS3.
For example - When I change the weight of pale malt, the mash water volumes for mash in, mash out and sparge water can change dramatically to erroneous values. The Grain Mash Weight is also not updated until I open the Mash tab (which forces another calculation of mash volumes). To correct the mash water volumes I have to re-select the mash profile from the list.
I also noticed that after adjusting the grain weight if I changed other values such as hops and yeast that the mash volumes also change. I'm new to BS, but I'm pretty sure the mash volume shouldn't change if I add a packet of yeast to the recipe.
Perhaps someone can confirm this behavior on their system?
I'm running a registered version of BS3 on Windows 7
Thanks