gearymeister
New Forum Member
- Joined
- Dec 17, 2018
- Messages
- 1
- Reaction score
- 0
I am brewing larger batches than my boil kettle can hold therefore I am adding top-up water to the fermenter when I transfer the wart.
I am noticing that although the estimated gravity figures for pre-boil and og are always spot on (its magic!) the expected post-boil gravity is showing the figure for the OG.
for example, I have a 54L batch here where I will be using 20L top-up.
the expected pre-boil gravity is 49.9 Litres @ 1.063
but expected post-boil gravity is 38.54 Litres @ 1.055
it would be nice if this figure was accurate to the stage rather than to the OG after the 20L of top-up is added.
Am I missing something?
Thanks in advance.
Chris
I am noticing that although the estimated gravity figures for pre-boil and og are always spot on (its magic!) the expected post-boil gravity is showing the figure for the OG.
for example, I have a 54L batch here where I will be using 20L top-up.
the expected pre-boil gravity is 49.9 Litres @ 1.063
but expected post-boil gravity is 38.54 Litres @ 1.055
it would be nice if this figure was accurate to the stage rather than to the OG after the 20L of top-up is added.
Am I missing something?
Thanks in advance.
Chris