• Welcome to the new forum! We upgraded our forum software with a host of new boards, capabilities and features. It is also more secure.
    Jump in and join the conversation! You can learn more about the upgrade and new features here.

Final Mash pH adjustments not calculating

T

toppa

I've set up the water profile and mash steps. When I adjust the measured mash pH to get an estimated addition of acid, the acid amount remains at 0.
When I add a quantity of acid in the "mash pH acid additions section" The adjusted mash pH figure becomes -1.#J which i'm assuming is an error.

Am I doing anything wrong or is this a bug?
I'm on 3.2.7
 
T

toppa

Figured it out!
Need to add strike water as part of the mash steps.
 
Top