Is there a way to add an additional timer step in the mash profile?
I would like to add a reminder 10 minutes into the mash to take a PH reading. I have tried to add an additional "Ingredient" on the Design tab which is set to mash for 50 minutes but, that didn't change anything on the timer tab. I have also tried to add a Mash step on the Mash Profile tab. In order for it to work I had to change the "Mash In" time to 10 minutes instead of 60. Then add the mash step (PH reading) as a 50 minute.
Is there another way to do this other than manipulating the information? With the PH reading being such an important step to make sure things are going as planned I would think that there would be a better way to do this.
I would like to add a reminder 10 minutes into the mash to take a PH reading. I have tried to add an additional "Ingredient" on the Design tab which is set to mash for 50 minutes but, that didn't change anything on the timer tab. I have also tried to add a Mash step on the Mash Profile tab. In order for it to work I had to change the "Mash In" time to 10 minutes instead of 60. Then add the mash step (PH reading) as a 50 minute.
Is there another way to do this other than manipulating the information? With the PH reading being such an important step to make sure things are going as planned I would think that there would be a better way to do this.