So confused
Measured Mash Efficiency in the design tab only changes when the Measured Pre-Vol changes, not when adjusting the pre-boil gravity. Now moving to the sessions tab, the measure post mash gravity does change the measured mash efficiency on both the sessions tab and the design tab.
The measure post mash gravity pop up indicates its out of the mash, with boil top up water. Well if you don't add any top up water, then the reading is the same so why doesn't the value in the design tab update the measured mash efficiency?
There has to be a better way to follow this
Rick
Measured Mash Efficiency in the design tab only changes when the Measured Pre-Vol changes, not when adjusting the pre-boil gravity. Now moving to the sessions tab, the measure post mash gravity does change the measured mash efficiency on both the sessions tab and the design tab.
The measure post mash gravity pop up indicates its out of the mash, with boil top up water. Well if you don't add any top up water, then the reading is the same so why doesn't the value in the design tab update the measured mash efficiency?
There has to be a better way to follow this
Rick