Unable To Change Total Volume

[Oginme]

The way around the issue with the Anvil, if you wish to use the recommendations given with the unit, is to select a BIAB profile and then modify your equipment profile to top off the boil kettle with the amount of water you wish to use in your sparge. This way the software will use the BIAB settings and calculate the total water needed for the brew. It will then subtract the top off water in your profile from the amount it calculates to give you a volume for the mash. You just use that "top off water" as your sparge volume through the grains. Don't worry, the software is not watching what you are actually doing

 

[addisonjerry79]

I agree that the interface is a bit confusing for those doing BIAB with a sparge (which is very common). Like mentioned, if I am doing a sparge with my BIAB process, I have to uncheck the BIAB option. I recall playing with the different sparge options and I think for me the best options were to check both 'Batch Sparge' and 'Drain Tun Before Sparge' options. I forget what worked for the 'Use Equal Batches' option.

I am mostly replying to note that you might have to tweak the Grain Absorption setting in the Advanced Options. There are two values there. One is for BIAB and is only used when the BIAB option is selected design agency. If you uncheck BIAB, then the other value is used. In my case, I set both values to the same value.

Yes it helpful for me