Author Topic: Volumes and units  (Read 2793 times)

Offline johngw9

  • BeerSmith Apprentice Brewer
  • **
  • Posts: 5
  • BeerSmith 2 Rocks!
Volumes and units
« on: November 14, 2016, 06:41:20 AM »
A couple questions: the brew steps sheet gives me the mash water volume in quarts but sparge water needs and all other volumes are in gallons, can all be set to one or the other? I've looked at volume options but don't see anyway to make the change, I'd prefer gallons on everything.

Also, on a batch brewed just yesterday I followed the stated volumes as closely as possible rounding to the nearest easily measurable point. I ended up with about 1.5 gallons of liquid still in the mash tun when the boil volume was reached in the kettle. I make the assumption my equipment profile has something set wrong. The brew steps gives a pre-boil volume higher than the boiler capacity. Any suggestions on what I should be looking at in the profile, or does anyone have parameters dialed in for a Brew Magic system? Thanks for the help.

Offline BeerSmith

  • Brewer, Author, Patriot
  • BeerSmith Administrator
  • BeerSmith Grandmaster Brewer
  • *****
  • Posts: 5598
  • BeerSmith - take the guesswork out of brewing!
    • BeerSmith
Re: Volumes and units
« Reply #1 on: November 24, 2016, 09:49:23 PM »
Yes,
  Go to Options->Units and set the mash units to "gallons".

  Regarding the equipment setup - yes if you are way off in your volumes then you probably need to take a look at your equipment profile.  Possibly you have a large mash addition field or lauter tun loss set?

Brad
Get a free trial of BeerSmith 3 here

 

modification