T
toppa
I've set up the water profile and mash steps. When I adjust the measured mash pH to get an estimated addition of acid, the acid amount remains at 0.
When I add a quantity of acid in the "mash pH acid additions section" The adjusted mash pH figure becomes -1.#J which i'm assuming is an error.
Am I doing anything wrong or is this a bug?
I'm on 3.2.7
When I add a quantity of acid in the "mash pH acid additions section" The adjusted mash pH figure becomes -1.#J which i'm assuming is an error.
Am I doing anything wrong or is this a bug?
I'm on 3.2.7