S
Swillbilly
I've been using Beersmith since October and I really like the program.. However, I'm having difficulty setting up my batch sparge water volumes. I typically do a single infusion batch sparge and I would like to achieve equal runoffs. When calculating the water needed, my strike water is substanially less than my sparge water volume. Case in point, this past weekend I brewed an Enlish Summer Ale with about 7.5 lbs of grain. My strike water was calculated to use something like 10 qts or 2.5 gallons and my sparge water volumes was something like 6.5 gallons to get 7.75 gallons pre-boil volume. How can I configure my sparge profile so that I can produce equal runoffs? I've selected the equal runoff box but my water volumes do no change. Thanks for any help. I've been making some really good beer, just want to make them even better.