K
kpowers11
Brad,
Is there any way to add a parameter in the equipment profile that would allow the program to add a set amount of water to the sparge water needed calculation based upon loss in my system. Essentially, I pump my sparge water back through a heat exchange coil in order to recover lost mash runnings during the heat exchange recirculating mash process. In exchange, however, some of my sparge water is left behind in my hoses and heat exchange coil as well as the very bottom of my HLT. It would help me greatly if there could be a parameter to compensate for this. As it is, I put a negative number in the top up water part of the equipment profile under the boiler section. This seems to accomplish what I want but seems a little clunky. Also, I am not sure what this is doing to other calculations the program is performing. Let me know what you think.
Ken
Is there any way to add a parameter in the equipment profile that would allow the program to add a set amount of water to the sparge water needed calculation based upon loss in my system. Essentially, I pump my sparge water back through a heat exchange coil in order to recover lost mash runnings during the heat exchange recirculating mash process. In exchange, however, some of my sparge water is left behind in my hoses and heat exchange coil as well as the very bottom of my HLT. It would help me greatly if there could be a parameter to compensate for this. As it is, I put a negative number in the top up water part of the equipment profile under the boiler section. This seems to accomplish what I want but seems a little clunky. Also, I am not sure what this is doing to other calculations the program is performing. Let me know what you think.
Ken