Author Topic: Honey as ingridient - brix vs SG calculations  (Read 1529 times)

Offline tibek

  • BeerSmith Apprentice Brewer
  • **
  • Posts: 5
  • BeerSmith 2 Rocks!
Honey as ingridient - brix vs SG calculations
« on: October 16, 2018, 02:08:02 AM »
Hi there,

Question about SG of honey as an ingredient - so far i've been using Canadian Honey Product Inspection manual. Chapter 5 ( ) has a table on page 5-12 which lists brix measurment, sg, moisture and refractive index.
Recently I discovered, that BS3 uses some different formula, as entering same measured brix i get different resutls.
Any idea why?

Offline brewfun

  • BeerSmith Grandmaster Brewer
  • *****
  • Posts: 2305
  • Malt dust is just alcohol's glitter
Re: Honey as ingridient - brix vs SG calculations
« Reply #1 on: October 16, 2018, 08:48:51 AM »
When the ingredient Type is set to Honey, you can enter the brix value without converting it to the "one pound dissolved to make 1 gallon" value that's used for grain.

The measurement difference is probably due to the fact that BeerSmith uses the sucrose value of Brix refraction. The document you cited seems to be adjusting for fructose.

Various sugars have slightly different refractive values. The difference is minor enough that brewers are ok citing the refraction of maltose and dextrines in in the sucrose scale value. There are adjustment calculations available for better precision, if desired.
Beer Appreciation is the space between pints.