Author Topic: Sparge water unit  (Read 1163 times)

Offline Boumba

  • BeerSmith New Brewer
  • *
  • Posts: 2
  • BeerSmith 2 Rocks!
Sparge water unit
« on: October 30, 2019, 07:51:53 AM »
Hi there,

I made a search and the same question was asked in 2005, but no update.

Would it be possible to add an option to display sparge water in qt instead of gal in the Mash tab? The initial quantity is displayed in qt, but when doing batch sparge, the other steps are displayed in gal.

I use a measuring cup to add sparge water (like many other i guess), and its much easier to have the qt quantity than gal, as this is readily available on the measuring cup.

Thanks!

Offline BeerSmith

  • Brewer, Author, Patriot
  • BeerSmith Administrator
  • BeerSmith Grandmaster Brewer
  • *****
  • Posts: 5597
  • BeerSmith - take the guesswork out of brewing!
    • BeerSmith
Re: Sparge water unit
« Reply #1 on: November 03, 2019, 03:59:15 PM »
You can't set the batch and mash units to quarts under Options->Units?

Brad
Get a free trial of BeerSmith 3 here

Offline Boumba

  • BeerSmith New Brewer
  • *
  • Posts: 2
  • BeerSmith 2 Rocks!
Re: Sparge water unit
« Reply #2 on: November 03, 2019, 05:59:01 PM »
This is exactly my issue. My setting is already to display mash in qt


But then in my mash tab, the sparge water is still displayed in gal


I would like to display sparge quantity in qt, just like for the initial water required, so its easier to add using my measuring cup