Author Topic: MoreBeer - Heavy Duty 15 Gallon Brew Kettle w/ball valve  (Read 5216 times)

Offline drb1215

  • BeerSmith Grandmaster Brewer
  • *****
  • Posts: 166
  • BeerSmith 2 Rocks!
MoreBeer - Heavy Duty 15 Gallon Brew Kettle w/ball valve
« on: December 04, 2013, 11:17:24 AM »
I recently upgraded my brew kettle to a 15 gallon MoreBeer heavy duty w/ball valve so that I can do full boils and start AG brewing.

I'm by all means no brewing expert, but quality and craftsmanship is something that is something that I can provide judgement on..

The build quality is excellent!  The welds for the ports are very clean.  The pot has 1.2 mm thick side walls, and a 5 mm thick bottom so heating is even, quick, and maintains heat so I use less fuel when keeping a boil over my old pot.

I've installed MoreBeer kettle diverter, so that I can drain all but 1/2 gallon out of the pot when moving my cooled wort to the fermenter.  Since the diverter pulls from the side (and low), very little of the hot break and hops end up in the fermenter. (a bit of whirlpooling helps)

If you are looking for a high quality brew kettle, that is reasonably priced, and will last a lifetime, check out the Heavy Duty MoreBeer kettles.  Highly recommended!

From 1 to 10, I would give it a 8.5...10 is one of the mystical numbers that means there is absolutely no room for improvement (saved for your spouse when you want a favor or if you are in the dog house!)

-Dan
« Last Edit: December 04, 2013, 11:21:51 AM by drb1215 »

Offline RobbyComstock

  • BeerSmith Brewer
  • ***
  • Posts: 47
  • Brewing Beer since 2011
    • Comstock Brewing
Re: MoreBeer - Heavy Duty 15 Gallon Brew Kettle w/ball valve
« Reply #1 on: December 05, 2013, 04:41:27 PM »
Thanks for the review Dan
Robby Comstock
@comstockbrewing


 

modification